5 Disconnect the SD module cable.
6 Pull back slightly on the tabs at the edge of the card and gently lift the
edge of the card off of the retention standoffs.
7 Install the I/O card. See "Installing the I/O Card" on page 135.
8 Close the system. See "Closing the System" on page 90.
9 Reconnect the system and peripherals to their power sources, and turn
them on.
Figure 3-26. Removing and Installing the Internal Dual SD Module
2
1
1
retention standoff posts (3)
3
SD module cable
140
Installing System Components
2
retention standoff tabs (3)
4
dual SD module
3
4