Configuring The Nec Snmp Agent For Windows Nt - NEC POWERMATE 5100 Service Manual

T
Click

Configuring the NEC SNMP Agent for Windows NT

Configure the NEC SNMP Agent for Windows NT as follows.
1. In the Windows taskbar, click
Panel .
2. At the Control Panel, double click the
3. At the Network screen, click the
4. At the Select Network Services screen, highlight
.
OK
5. At the Microsoft SNMP Properties screen, there are three properties that
must be set:
T
Security — Limits the set of computers than can perform SNMP
management on this computer to those in the community and/or specific
computer names the user provides.
T
Traps — Limits the set of computers that receive traps from this
computer to those in the community and/or specific computer names the
user provides.
Note:
NEC Desktop Manager and HP OpenView, IP addresses
(for example, 157.123.176.100) must be entered in the
Traps for "Public Community" to receive traps from the NEC
SNMP agents.
For the NEC SNMP Agent to send a trap to the NEC SNMP
Desktop Manager, the port number can be configured from
the registry:
"HKEY_LOCAL_MACHINE\SOFTWARE\Packard Bell
NEC,Inc.\PBNEC SNMP Desktop Agent\Port Number".
The default port number is set to 55593.
T
Agent — Allows the user to specify a contact name and location for the
computer.
6. Edit the properties.
7. Click
OK
8. Click
Close
File and click Exit .
Start
For an SNMP management console, such as the
to return to the Network screen.
to return to the Windows screen.
, point to Settings, and click
Network icon.
Services tab and click
SNMP Service
System Configuration 2-53
Control
Add .
, and click