Checking System Memory; Supported Dimms; Sample Dimm Upgrade Paths - NEC POWERMATE 5100 Service Manual

See the following tables for supported DIMMs and for sample DIMM upgrade
paths. To determine the memory needed for a memory upgrade, see "Checking
System Memory." To remove or install a DIMM, see Section 3, "Disassembly
and Reassembly." Pin assignments for the DIMM sockets are included at the
end of this section.
DIMM
16 MB
32 MB
64 MB
128 MB
DIMM 1
16 MB
32 MB
32 MB
32 MB
64 MB
64 MB
64 MB
64 MB
128 MB
*The information in this table shows sample DIMM upgrade paths; it does not represent
every combination of DIMMs supported in the system.

Checking System Memory

If you do not know how much memory is installed in the system, check the
amount as follows.
1. On the Windows 95, Windows 98, or Windows NT 4.0 desktop, point to
Computer
2. With the left mouse button, click
random access memory (RAM). This is the amount of system memory in the
computer.
In Windows 95 or Windows 98, find the amount of memory by pointing to
Computer
4-10 System Board

Supported DIMMs

Type
CAS Latency 2 SDRAM
CAS Latency 2 SDRAM
CAS Latency 2 SDRAM
CAS Latency 2 SDRAM

Sample DIMM Upgrade Paths*

DIMM 2
16 MB
--
16 MB
32 MB
--
16 MB
32 MB
64 MB
128 MB
and click the right mouse button.
, clicking the right mouse button, and selecting
Configuration Technology
2 Mbit x 64 16 Mbit
4 Mbit x 64 16 Mbit
8 Mbit x 64 16 Mbit
16 Mbit x 64 16 Mbit
Total Memory
32 MB
32 MB
48 MB
64 MB
64 MB
80 MB
96 MB
128 MB
256 MB
. The
Properties General
Performance
My
tab shows the
My
.