Quantum Fireball 8.4-Gb Ide Hard Drive Jumper Settings; Nec 32X Cd-Rom Drive Jumper Settings; Quantum Fireball 8.4-Gb Ibm Ide Hard Drive Jumper Settings - NEC POWERMATE 5100 Service Manual

Quantum Fireball 8.4-GB IDE Hard Drive Jumper Settings

The factory settings for the jumpers on the Quantum Fireball 8.4-GB IDE hard
drive are shown in the following table. The settings are for a single drive
installed in the system. Specifications for the hard drives are included in
Section 10.

Quantum Fireball 8.4-GB IBM IDE Hard Drive Jumper Settings

Function
Master Device
(Drive Select)
Slave Device
Cable Select
(CS)
Park

NEC 32X CD-ROM Drive Jumper Settings

The factory settings for the jumpers on the NEC 32X CD-ROM drive are shown
in the following table. The drive is set as the master device on the secondary
channel. The CD-ROM cable plugs onto the Secondary IDE connector on the
riser board. Specifications for the CD-ROM drive are included in Section 10.
Jumper
Cable Select (CS)
Slave Present (SL)
Master Select (MA)
2-8 System Configuration
Jumper Pins Description
DS-1 and Sets hard drive as master device in single drive system or
DS-2 dual drive system. Factory setting: pins DS-1 and DS-2
jumpered.
DS-1 and Sets hard drive as slave in dual drive system.
DS-2
CS-1 and Not used. Factory setting: pins CS-1 and CS-2 open.
CS-2
PK-1 and Used to park DS jumper when drive set as slave device.
PK-2 Factory setting: pins PK-1 and PK-2 open.

NEC 32X CD-ROM Drive Jumper Settings

Jumper Pin Settings
Not used.
Disabled, pin 2 open (factory default).
Enabled, pin 2 jumpered.
Enabled, pin 3 jumpered (factory default).
Disabled, pin 3 open.