Installing The Nec Snmp Agent; Configuring The Nec Snmp Agent For Windows 95 - NEC POWERMATE 5100 Service Manual

T
Help Desk Support — provides information such as BIOS versions.
T
Alert Notification — provides alerts when thresholds are exceeded (for
example, when temperatures exceed specified limits in a computer).
SNMP managed devices on a network send messages (traps) when a preset level
of device activity occurs. Notification of events with SNMP traps is sent to a
network manager upon reaching either a user-specified over-threshold or under-
threshold condition for any supported management information base (MIB)
variable.
The following paragraphs describe how to install and configure the NEC SNMP
Agent on Microsoft Windows 95, Windows 98, or Windows NT configured
systems.
Before installing the NEC SNMP Agent from the NEC Select
Install CD, refer to Appendix A, "NEC PowerMate 5100
Series Release Notes," for the correct order in which to
install applications.

Installing the NEC SNMP Agent

The NEC SNMP Agent software is on the NEC Select Install CD. Install the
software on a Windows 95, Windows 98, or Windows NT configured system as
follows. (The NEC SNMP Agent software can also be downloaded from the
NEC CSD website at
Do not install both the NEC SNMP Agent and LANDesk
Client Manager on the same computer.
1. Close all open applications before installing the NEC SNMP Agent.
2. Insert the NEC Select Install CD into the CD-ROM drive. Click
when prompted.
3. Click
Start
where
4. Click
OK

Configuring the NEC SNMP Agent for Windows 95

The SNMP Agent is configured with the Windows 95 Policy Editor. The Policy
Editor configures the traps, communities, and other policies.
2-50 System Configuration
! CAUTION
www.nec-computers.com
! CAUTION
on the taskbar, point to and click
E:\NECUtil\NEC_SNMP\setup.exe
E: is the CD-ROM drive.
and follow the prompts to install the software.
.)
Cancel
Run , and type