Exit Menu; Maintenance Menu; Exit Menu Options; Maintenance Menu Options - NEC POWERMATE 5100 Service Manual

Exit Menu

Selecting the Exit menu displays the exit options listed in the following table.
Menu Item
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults

Maintenance Menu

The Maintenance menu only appears when the system board has been jumpered
for Configure mode. (See Section 4, "System Board" for system board jumper
settings.) When the system is restarted in Configure mode, the Setup utility
launches automatically and comes up in the Maintenance menu. (The Main,
Advanced, Power Management, Security, Boot, and Exit menus are also
available.)
The Maintenance menu provides access to the options listed in the following
table.
Starting the system in Configure mode resets BIOS settings
to their factory defaults. Before jumpering for Configure
mode, write down any customized BIOS settings. When the
system is started in Normal mode, press
BIOS Setup utility. Re-customize the BIOS settings.
Menu Item
Processor Speed
Clears All Passwords
2-24 System Configuration

Exit Menu Options

Settings and Description
Saves the setting just made and exits BIOS.
Discards the changes just made and reverts back to the
settings existing before starting the BIOS session.
Reverts to the factory-shipped settings.
! CAUTION
F2

Maintenance Menu Options

Settings and Description
Sets the following processor speeds:
233 MHz, 266 MHz, 300 MHz, 333 MHz
[Enter]
Clears the User and Supervisor passwords.
Press Enter to open a dialog box asking for confirmation
that the passwords should be cleared.
to bring up the