Serial Port Interrupts
The interrupts for serial port 1 and serial port 2 are given in the following table.
Any interrupts used for the built-in serial ports are not available for ISA parallel
ports. Also, if serial ports share an interrupt, verify that hardware and software
added to the system can share these interrupts without problems.
Port
COM1
COM2
COM3
COM4
COM1
COM2
COM3
COM4
Jumper Settings
Jumpers on the boards and devices in the system are used to set the system
configuration. Boards and devices using jumpers include:
T
system board
T
riser board
T
IDE hard drives
T
CD-ROM drives
T
fax/modem board.
The following paragraphs list the jumpers and their factory settings.
Note: Jumpers are set correctly at the factory for the
system configuration. If a jumper change is required, change
only the setting for that condition (see Section 4 and
Section 5 for procedures on setting jumpers).
2-4 System Configuration
Serial Port 1 and Serial Port 2 Interrupts
Interrupt
IRQ04
IRQ03
IRQ04
IRQ03
IRQ03
IRQ04
IRQ03
IRQ04