Hard Drive Jumper Settings
Hard drive jumpering varies according to the particular model in the system and
how that model is configured. The following hard drive models are available for
your system from NEC CSD:
T
Seagate Maui 2.1-GB
T
Fujitsu Pico Bird 4.3-GB
T
Quantum Fireball 6.4-GB
T
Quantum Fireball 8.4-GB.
Note: Other hard disks may also be available for the
system. Jumper settings are included on a label attached to
the top of the drive. Refer to the label for correct jumper
settings for your system's configuration.
Seagate Maui 2.1-GB IDE Hard Drive Jumper Settings
The factory settings for the jumpers on the Seagate Maui 2.1-GB IDE hard drive
are shown in the following table. The settings are for a single drive installed in
the system. Specifications for the hard drives are included in Section 10.
Function
Master Device
(Drive Select)
Slave Device
Cable Select
(CS)
2-6 System Configuration
Seagate Maui 2.1-GB IDE Hard Drive Jumper Settings
Jumper Pins
Description
5 and 6
Sets hard drive as master device in single drive system or
dual drive system.
Not jumpered
Sets hard drive as slave in dual drive system.
(all pins open)
3 and 4
Not used.