Fujitsu Pico Bird 4.3-Gb Ide Hard Drive Jumper Settings; Quantum Fireball 6.4-Gb Hard Drive Jumper Settings; Quantum Fireball 6.4-Gb Ide Hard Drive Jumper Settings - NEC POWERMATE 5100 Service Manual

Fujitsu Pico Bird 4.3-GB IDE Hard Drive Jumper Settings

The factory settings for the jumpers on the Fujitsu Pico Bird 4.3-GB IDE hard
drive are shown in the following table. The settings are for a single drive
installed in the system. Specifications for the hard drives are included in
Section 10.

Fujitsu Pico Bird 4.3-GB IDE Hard Drive Jumper Settings

Function
Master Device
(Drive Select)
Slave Device
Cable Select
(CS)

Quantum Fireball 6.4-GB Hard Drive Jumper Settings

The factory settings for the jumpers on the Quantum Fireball 6.4-GB IDE hard
drive are shown in the following table. The settings are for a single drive
installed in the system. Specifications for the hard drives are included in
Section 10.

Quantum Fireball 6.4-GB IDE Hard Drive Jumper Settings

Function
Master Device
(Drive Select)
Slave Device
Cable Select
(CS)
Park
Jumper Pins Description
2 6
Sets hard drive as master device in single drive system or
5
1
dual drive system.
2 6
1 Sets hard drive as slave in dual drive system.
5
2 6
Not used.
1
5
Jumper Pins Description
DS-1 and Sets hard drive as master device in single drive system or
DS-2 dual drive system. Factory setting: pins DS-1 and DS-2
jumpered.
DS-1 and Sets hard drive as slave in dual drive system.
DS-2
CS-1 and Not used. Factory setting: pins CS-1 and CS-2 open.
CS-2
PK-1 and Used to park DS jumper when drive set as slave device.
PK-2 Factory setting: pins PK-1 and PK-2 open.
System Configuration 2-7