Snapshot Images; Figure 182 Protect > Snapshot > Snapshot Images; Table 85 Protect > Snapshot > Add Job - ZyXEL Communications NSA-2401 User Manual

The following table describes the labels in this screen.
Table 85 Protect > Snapshot > Add Job
LABEL
Job Name
Volume Name
Max. Number of Snapshot
Image(s)
Period
Apply
Cancel

9.4.2 Snapshot Images

Click Protect > Snapshot > Snapshot Images tab to open the following screen. Click a
column's heading cell to sort the table entries by that column's criteria. Click the heading cell
again to reverse the sort order.
Figure 182 Protect > Snapshot > Snapshot Images
NSA-2401 User's Guide
DESCRIPTION
This is a required field that uniquely identifies the snapshot. Type from 1
to 15 characters. You can use alphanumeric characters (A-Z 0-9) and "_"
[underscores]. The first character must be a letter.
Select the (internal) volume to take a snapshot of.
When creating a new snapshot, only volumes that are already created on
the NSA are available.
Note: You can only create one snapshot job per volume.
A snapshot must be done on a complete volume, and not a single file or
folder. However you can restore files from a snapshot on an individual file-
by-file basis.
Select the number of snapshot images to take from 1 to 5. It's strongly
recommended to set this as low as possible as each new snapshot image
created will reduce the NSA's file write performance.
Select how often the job should run (Hourly, Daily, or Weekly). It is
recommended you schedule snapshots for times when your network is
not busy, such as at night. If two events are configured to run at the same
time, then one must wait until the other finishes running.
Enter the time, and/or day as appropriate for your selection.
Click this button to save your changes back to the NSA.
Click this button to discard your changes and exit the screen.
Chapter 9 Protect Screens
217