Example No Commands; Figure 29-12 Cli: Boot Config Command Example; Figure 29-13 Cli: Reload Config Command Example; Figure 29-14 Cli: Reset To The Factory Default Example - ZyXEL Communications Dimension GS-3012F User Manual

GS-3012F# boot config 2
Use the reload config command to restart the system and use a different configuration file (if specified). The
following example restarts the system to use the second configuration file.
GS-3012F# reload config 2
When you use the
write memory
the switch saves the changes to the configuration file the switch is currently using.
29.6.4 Resetting to the Factory Default
Follow the steps below to reset the switch back to the factory defaults.
Enter erase running config to reset the current running configuration.
1.
Enter
2.
write memory
second configuration file, use the
The following example resets both configuration files to the factory default settings.
GS-3012F# erase running-config
GS-3012F# write memory
GS-3012F# write memory 2

29.7 Example no Commands

These are the commonly used command examples that belong to the "no" group of commands.
29.7.1 no mirror-port
Syntax:
no mirror-port
Disables port mirroring on the switch.
An example is shown next.
Command Examples

Figure 29-12 CLI: boot config Command Example

Figure 29-13 CLI: reload config Command Example

command without specifying a configuration file index number,
to save the changes to the current configuration file. If you want to reset the
write memory

Figure 29-14 CLI: Reset to the Factory Default Example

Dimension GS-3012F Gigabit Ethernet Switch
command again with the specified index number.
29-7