Table 28-5 Command Summary: Interface; Interface Commands - ZyXEL Communications Dimension GS-3012F User Manual

28.9.5

interface Commands

The following commands are listed in configuration mode as "interface" switch commands; all are preceded with
the command
interface.
interface
<port-
list>
bandwidth-limit
bandwidth-limit
egress
bandwidth-limit
ingress
broadcast-limit
broadcast-limit
multicast-limit
multicast-limit
dlf-limit
dlf-limit
spq
wrr
Introduction to CLI
Table 28-4 Command Summary: config-vlan Commands
COMMAND

Table 28-5 Command Summary: Interface

COMMAND
<Mbps>
<Mbps>
<pkt/s>
<pkt/s>
<pkt/s>
Dimension GS-3012F Gigabit Ethernet Switch
<ip-address>
<mask>
manageable
<ip-address>
<mask>
DESCRIPTION
Allows the switch to be managed using
this specified IP address.
Sets the IP address and subnet mask of
the switch in the specified VLAN for
packet loopback test.
DESCRIPTION
Enables a port or a list of ports
for configuration.
Enables bandwidth limit on the
switch.
Sets the maximum bandwidth
allowed for outgoing traffic on the
switch.
Sets the maximum bandwidth
allowed for incoming traffic on
the switch.
Enables broadcast storm control
limit on the switch.
Sets how many broadcast
packets the interface receives
per second.
Enables the interface multicast
limit.
Sets how many multicast packets
the interface receives per
second.
Enables the Destination Lookup
Failure (DLF) limit.
Sets the interface DLF limit in
packets per second (pps).
Sets the interface to use Strict
Priority Queuing.
Sets the interface to use
Weighted Round Robin queuing
(WRR).
28-21