Figure 25-5 Configuring Cluster Management; Table 25-4 Configuring Cluster Management - ZyXEL Communications Dimension GS-3012F User Manual

The following table describes the labels in this screen.
LABEL
Clustering
Manager
Active Select Active to have this switch become the cluster manager switch. A cluster can only have one
manager. Other (directly connected) switches that are set to be cluster managers will not be visible
in the Clustering Candidates list. If a switch that was previously a cluster member is later set to
become a cluster manager, then its Status is displayed as Error in the Cluster Management
Status screen and a warning icon (
Name Type a name to identify the Clustering Manager. You may use up to 32 printable characters (no
spaces are allowed).
VID This is the Management VLAN ID and is only applicable if the switch is set to 802.1Q VLAN. All
switches must be in the same management VLAN group to belong to the same cluster. Switches
that are not in the same management VLAN group are not visible in the Clustering Candidates
list. This field is ignored if the Clustering Manager is using Port-based VLAN.
Apply Click Apply to save these changes to the switch.
Cluster Management

Figure 25-5 Configuring Cluster Management

Table 25-4 Configuring Cluster Management

DESCRIPTION
) appears in the member summary list below.
GS-3012F User's Guide
25-5