Figure 4-4 Resetting The Switch: Via Console Port; Figure 4-5 Web Configurator: Logout Screen; Logging Out Of The Web Configurator - ZyXEL Communications Dimension GS-3012F User Manual

be reset to the default of 9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The
password will also be reset to "1234" and the IP address to 192.168.1.1.
To upload the configuration file, do the following:
Connect to the console port using a computer with terminal emulation software. See the chapter on
1.
hardware connections for details.
Disconnect and reconnect the switch's power to begin a session. When you reconnect the switch's power,
2.
you will see the initial screen.
When you see the message "Press any key to enter Debug Mode within 3 seconds"
3.
press any key to enter debug mode.
Type atlc after the "Enter Debug Mode" message.
4.
Wait for the "Starting XMODEM upload" message before activating XMODEM upload on your
5.
terminal.
After a successful configuration file upload, type atgo to restart the switch.
6.
Bootbase Version: V1.0 | 04/25/2003 10:01:06
RAM: Size = 32768 Kbytes
FLASH: Intel 32M
ZyNOS Version: V3.60(LH.0)b5 | 03/2/2004 18:00:29
Press any key to enter debug mode within 3 seconds.
....................
Enter Debug Mode
GS-3012F> atlc
Starting XMODEM upload (CRC mode)....
CCCCCCCCCCCCCCCC
Total 393216 bytes received.
Erasing..
................................................................
OK
The switch is now reinitialized with a default configuration file including the default password of "1234".
4.5.1

Logging Out of the Web Configurator

Click Logout in a screen to exit the web configurator. You have to log in with your password again after you log
out. This is recommended after you finish a management session both for security reasons and so as you don't
lock out other switch administrators.
Introducing the Web Configurator

Figure 4-4 Resetting the Switch: Via Console Port

Figure 4-5 Web Configurator: Logout Screen

GS-3012F User's Guide
4-7