Enabling Rstp; Configuration File Maintenance; Restarting The Switch; Figure 105 Traceroute Command Example - ZyXEL Communications ES-2024A User Manual

where
<ip>
[vlan <vlan-id> ] =
[ttl <1-255>]
[wait <1-60>]
[quesries <1-10>] =
This command displays information about the route to an Ethernet device. The following
example displays route information to an Ethernet device with an IP address of
192.168.1.100

Figure 105 traceroute Command Example

ras> traceroute 192.168.1.100
traceroute to 192.168.1.100, 30 hops max, 40 byte packet
1:192.168.1.100 (10 ms) (10 ms) (0 ms)
traceroute done:

28.5 Enabling RSTP

To enable RSTP on a port. Enter
.
[ENTER]
The following example enables RSTP on port 10.

Figure 106 Enable RSTP Command Example

ras(config)# spanning-tree 10
ras#

28.6 Configuration File Maintenance

The following sections shows how to manage the configuration files.

28.6.1 Restarting the Switch

There are two ways in which you can restart the switch: restart the switch (cold reboot) and
restart the system (warm reboot).
Use the
boot config
example.
Chapter 28 Command Examples
The IP address of an Ethernet device.
=
Specifies the VLAN ID to which the Ethernet device belongs.
Specifies the Time To Live (TTL) period.
=
Specifies the time period to wait.
=
Specifies how many tries the switch performs the traceroute
function.
.
spanning-tree
command to restart the switch. The following figure shows an
ES-2024A User's Guide
followed by the port number and press
171