Replacing The Fuse - SATO M-8485Se Operator And Technical Reference Manual

Section 4.cleaning and Maintenance
NOTE: Be careful not to scratch the printing surface of the print head while installing
it. Scratching the surface will cause permanent and irreparable damage and is not
covered by the warranty!
9. Locate the mounting screw in the top plate assembly and align it with the tapped
hole in the new print head.
10. Re-secure the print head by tightening the screw.

REPLACING THE FUSE

Supplies needed:
1. Turn the printer power off and remove the power cable.
2. On the back of the printer, locate the Fuse Cap directly above the AC connector.
3. Unscrew the cap and remove the defective fuse.
4. Replace with a new 250V 15A fuse.
5. Screw the fuse cap back onto the printer and replace the power cable.
AC Fuse
AC Input
Connector
Page 4-6
PN 9001073 Rev C
250V 15A Fuse
SATO "Se" Print Engines