SATO M-8485Se Operator And Technical Reference Manual page 28

Section 2. Installation
ADJUSTING SENSOR POSITION
The label gap (transmissive) sensor can be positioned over a limited . The movable
sensor assembly is mounted on the Label Hold Down and is held in position by two
screws. To adjust the position of the sensor, both screws must be loosened and the
sensor moved to the desired position in the slot, and then the screws retightened.
Adjustments to compensate for different liner opacity is done with the LCD panel.
Page 2-10
Sensor Adjust
(shown open)
Slot
PN 9001073 Rev C
Print Head
Sensor Position
Screws
SATO "Se" Print Engines