SATO M-8485Se Operator And Technical Reference Manual page 33

Head Check Selection (DSW2-3). When selected, the printer will check for head
elements that are electrically malfunctioning.
DSW2-3
Off
On
Hex Dump Selection (DSW2-4). Selects Hex Dump mode (see page 3-21).
DSW2-4
Off
On
Receive Buffer Selection(DSW2-5). Selects the operating mode of the receive
buffer. See Section 6: Interface Specifications for more information.
DSW2-5
Firmware Download (DSW2-6). Places the printer in the Firmware Download
mode for downloading new firmware into flash ROM.
DSW2-6
Protocol Code Selection (DSW2-7). Selects the command codes used for
protocol control. Refer to page E-1 for more information.
DSW2-7
M8400S Emulation Mode (DSW2-8). For emulating earlier series software
commands. Should be used only if problems are encountered when using existing
software. This switch will also affect the settings selected by DSW1-7 and DSW1-8.
DSW2-8
SATO "Se" Print Engines
SETTING
Disabled
Enabled
SETTING
Disabled
Enabled
SETTING
Off Single Job
On Multi Job
SETTING
Off Disabled
On Enabled
SETTING
Off Standard
On Non-Std
SETTING
Off Disabled
On Enabled
PN 9001073 Rev C
Section 3. Configuration
DSW2
ON
OFF
1 2 3 4
DSW2
ON
OFF
1 2 3 4
DSW2
ON
OFF
1 2 3 4
DSW2
ON
OFF
1 2 3 4
DSW2
ON
OFF
1 2 3 4
DSW2
ON
OFF
1 2 3 4
5 6 7 8
5 6 7 8
5 6 7 8
5 6 7 8
5 6 7 8
5 6 7 8
Page 3-3