Installing And Adjusting The Cinewide Anamorphic Lens; Attach Lens Mounting Assembly To Lens Motor Carriage Plate; Anamorphic Lens Mouning Assembly - Exploded View - Runco Signature Cinema SC-1 Owner's Operating Manual

If you are installing a CineWide-equipped projector, proceed as follows to install and
adjust the anamorphic lens.
It is extremely important that the primary lens is properly
Note
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
The SC-1 Anamorphic lens mount kit consists of everything shown in Figure 3-27. Some
components shipped with your projector may differ slightly from what is shown in these
instructions. If any items are missing or damaged, please contact your Runco dealer or
Runco Customer Service at (800) 23-RUNCO.
1
10 Anamorphic Lens
Set Screw
9
Pitch Adjustment
T-Nut (2x)
Yaw/X Adjustment
8
Lever (2x)
Figure 3-27. Anamorphic Lens Mouning Assembly - Exploded View
1. Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the
Anamorphic Lens Holder (item #5).
2. Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate (item #7).
Position the bracket so that the long slot at the bottom of the lens holder is
perpendicular to the corresponding slots on the carriage plate.
Runco SC-1 Owner's Operating Manual
Lens Adapter Ring and
Mounting Screws (3x)
2 Pitch Adjustment Yoke for Lens
3
Height/Y Adjustment
T-Screw (2x)
4
Pitch Adjustment
T-Screw (2x)
5
Anamorphic Lens
Holder
6 1/4-20 Hex Bolt (2x)
and Washer (2x)
7
AutoScope Carriage Plate
49
Installation
3.12
Installing and
Adjusting the
CineWide Anamorphic
Lens
Attach Lens Mounting
Assembly to Lens Motor
Carriage Plate