Quick Setup - Runco Signature Cinema SC-1 Owner's Operating Manual

Installation
3.2

Quick Setup

Table 3-1 gives a quick overview of the SC-1 installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video
Note
installation specialist.
Table 3-1. Installation Overview
Step
1 Choose a location for the projector
2 Install primary projection lens, lamp and heat extractor
3 Install CineWide lens mounting assembly (stationary base
plate or AutoScope lens motor – optional)
4 Mount the projector
5 Connect the DHD Controller to the projector
6 Connect signal sources to the DHD Controller
7 Connect external controller to RS-232 port (optional)
8 Connect AutoScope lens motor and/or other equipment to
12-volt trigger outputs (optional)
9 Connect power supply/lamp ballast, if separate from
projection head (split-body configuration)
10 Apply power to the projector
11 For rear-screen installations, select the proper picture
orientation
12 Primary lens adjustments: projected image size (zoom),
position (shift) and focus
13 Install CineWide anamorphic lens (optional)
14 CineWide lens adjustments: position, pitch (angle),
geometry and focus
15 Calibrate projector input 2 (DVI): perform Auto Setup, then
adjust size/position, input levels, brightness/contrast etc.,
as needed for each channel
16 Adjust lamp output, as needed
17 DHD Controller input calibration: adjust the following for
each DHD Controller input; save settings when finished:
• Aspect ratio
• Brightness
• Contrast
Procedure
• Color level
• Tint
• Input position
18
For Details, Refer to
page...
19
24
29
31
32
34
38
38
40
43, 44
47
22, 47
49
51
54
66
71 through 79
Runco SC-1 Owner's Operating Manual