Power-Up Sequence - Runco Signature Cinema SC-1 Owner's Operating Manual

1. Turn on your source components.
2. Turn on the main power switch at the rear of the DHD Controller.
3. If this is an AutoScope-equipped projector, turn on the main power switch on the
AutoScope lens motor. The lens motor power switch is located next to the AC input
(see Figure 3-19).
4. Press the ON button on the remote control – or the POWER button on the DHD
Controller front panel – to turn on the system. The vacuum fluorescent display on the
DHD Controller front panel briefly displays "Starting Display."
The LED status window at the rear of the projector displays an active pattern of
segments to indicate that it is changing its state from "standby" to "on."
5. When the projector has completed its initialization and is ready
for use, "On" appears in the projector LED status window.
The fluorescent display on the DHD Controller indicates the active source, signal format
(NTSC or PAL), input resolution and aspect ratio; for example:
Current Source
Component SD NTSC
Cinema
Aspect Ratio
Runco SC-1 Owner's Operating Manual
Format Resolution
Input
480i
SC-1
45
Installation

Power-Up Sequence