Attach Extension Bracket To Lens Motor; Install Anamorphic Lens Motor; Autoscope Lens Motor With Extension Bracket; Sc-1 With Autoscope Lens Motor (Bottom View) - Runco Signature Cinema SC-1 Owner's Operating Manual

Installation
Attach Extension Bracket
to Lens Motor
Install Anamorphic Lens
Motor
➤
Use the supplied hardware to attach the lens motor extension bracket to the top of the
lens motor as shown in Figure 3-10.
Figure 3-10. AutoScope Lens Motor with Extension Bracket
➤
Note
Line up the 10 mounting holes on the lens motor extension bracket with those on the
bottom of the projector. Secure the motor to the projector with the 10 screws provided for
this purpose. See Figure 3-11.
Lens
Motor
Figure 3-11. SC-1 with AutoScope Lens Motor (Bottom View)
Caution
The anamorphic lens mounting kit is partially pre-assembled at the
factory – the AutoScope lens motor and lens mounting assemblies
are both fully assembled.
Extension
Bracket
DO NOT OVER-TIGHTEN THE SCREWS.
30 Runco SC-1 Owner's Operating Manual