Channel Setup Menu - Runco Signature Cinema SC-1 Owner's Operating Manual

Installation
All available channels are listed in the Channel Setup menu (Figure 3-30), which describes
how each channel can be accessed and which serves as the gateway for editing, copying
and deleting channels.
01
02
03
04
05
06
07
08
09
<Enter> = Edit,
location
Figure 3-30. Channel Setup Menu
To display the Channel Setup menu, press 3 or highlight Channel Setup and press
ENTER or . The Channel Setup menu appears with the active channel highlighted.
What Appears in the Channel Setup Menu: This menu lists all channels defined so far
and indicates where they are connected on the input panel.
The far-left column lists channel numbers currently defined. If
a channel has been assigned a name, that name appears in
the far-right column; otherwise, the horizontal and vertical
frequencies of the input signal appear here instead. Remaining
columns contain details pertaining to each channel setup,
such as its switcher number (always 0 = projector), slot location, a variety of icons
indicating access to each channel, and an abbreviated description of each signal type.
Signal Type Abbreviations: The Channel Setup menu identifies signal types in a
shortened form. These descriptors indicate what signal information the projector uses to
identify a match for a given channel, and are preceded by either an "i" (for interlaced
signals) or "p" (for progressive signals).
When used with the DHD Controller, the HDMI output signal is represented by either
"pDig" or "iDig."
Unlocking Channels: Channels are pre-configured at the Runco factory for use with the
DHD Controller, and are locked to prevent the factory settings from being over-written
accidentally. For 1080i and 1080p digital signals, there are separate channels for each
aspect ratio and "ISF" memory preset (day and night).
Before proceeding with calibration, unlock the currently-active channel so that any
changes you make are stored in that channel.
Channel Setup
0,2 pDig dhd 720p
0,2 iDig 16x9 night
0,2 iDig 4x3 night
0,2 iDig ltrbox night
0,2 iDig vwide night
0,2 iDig cinema night
0,2 iDig vcine night
0,2 pDig 16x9 night
0,2 pDig 4x3 night
<Func> = more options
signal type channel name
58 Runco SC-1 Owner's Operating Manual