Runco Signature Cinema SC-1 Owner's Operating Manual page 97

• Film Mode: Enable Film Mode to smooth out moving images from interlaced,
standard-definition (SD) sources. In most cases, the DHD Controller detects the proper
"pull-down" rate and vertical frequency. However, if your source is jittery and/or tearing
you may wish to enable Film Mode to ensure stable processing for that source.
Resolution: When using the SC-1 with a computer or certain HD sources, you may want
to force the DHD Controller to use a specific output resolution. If so, select Resolution
from the Service menu and choose one. Then, press ENTER to confirm.
System Reset: To reset ALL projector and controller settings (including image settings)
back to their factory defaults, select System Reset from the Service menu.
A confirmation message appears, reminding you to save your settings before you perform
the reset, so that you can restore them afterwards. If you have done this, select Confirm to
continue with the reset. Otherwise, select Back to cancel.
This action is not undoable. Proceed with caution! Before you
Caution
perform a System Reset, save ALL settings, including "Custom" ISF
Presets (page 79), ISF Day/Night presets (page 81), Output Shift
settings (page 81), Input Names (page 82) and Trigger settings
(page 84).
Restore Saved Settings: Following a System Reset, select Restore Saved Settings to
apply all previously-saved settings to the projector and DHD Controller.
Runco SC-1 Owner's Operating Manual 85
Operation