Runco Signature Cinema SC-1 Owner's Operating Manual page 112

Maintenance and Troubleshooting
Table 5-2. SC-1 Error Codes (continued)
Code
80 Unrecognized IRAM (panel driver).
81 Unable to program device on IRAM.
82 TI flash download failure.
83 TI flash download fault; partial success.
84 TI flash download fault; partial success.
85 TI-I2C write failure.
87 Consecutive faults from modular Formatters.
90 Red modular Formatter communication failure.
91 Green modular Formatter communication failure.
92 Blue modular Formatter communication failure.
93 Modular formatter architecture error.
94 Modular formatter/DMD mismatch.
95 Modular formatter sequence mismatch.
96 EFIB not responding to I2C messages.
A0 Unable to program the optional interface module.
A1 Unable to power the optional interface module.
A2 Unable to program the Dual Slot Backplane Module (DSBP).
A3 Unable to program the optional Post Processing Module (Warp module).
Note: To clear a system error, press the EXIT key (on the SC-1 control panel) twice. If necessary,
reset the projector by powering it off, allowing it to cool and powering it on again. Contact your
Runco dealer or Runco technical support if the error persists.
Description
Panel Driver and Formatter
Miscellaneous
100 Runco SC-1 Owner's Operating Manual