Errdisable Recovery - Cisco WS-C2350-48TD-S Command Reference Manual

errdisable recovery

errdisable recovery
Use the errdisable recovery global configuration command to configure the recovery mechanism
variables. Use the no form of this command to return to the default setting.
Syntax Description cause
all
bpduguard
channel-misconfig
dtp-flap
gbic-invalid
l2ptguard
link-flap
loopback
pagp-flap
sfp-config-mismatch
small-frame
udld
interval interval
Defaults
Recovery is disabled for all causes.
The default recovery interval is 300 seconds.
Catalyst 2350 Switch Command Reference
2-62
errdisable recovery {cause {all | bpduguard | channel-misconfig | dtp-flap | gbic-invalid |
l2ptguard | link-flap | loopback | pagp-flap | sfp-mismatch | small-frame | udld}} | {interval
interval}
no errdisable recovery {cause {all | bpduguard | channel-misconfig | dtp-flap | gbic-invalid |
l2ptguard | link-flap | loopback | pagp-flap | sfp-mismatch | small-frame | udld}}| {interval
interval}
Enable the error-disabled mechanism to recover from a specific cause.
Enable the timer to recover from all error-disabled causes.
Enable the timer to recover from the bridge protocol data unit (BPDU) guard
error-disabled state.
Enable the timer to recover from the EtherChannel misconfiguration
error-disabled state.
Enable the timer to recover from the Dynamic Trunking Protocol (DTP) flap
error-disabled state.
Enable the timer to recover from an invalid Gigabit Interface Converter
(GBIC) module error-disabled state.
Note
Enable the timer to recover from a Layer 2 protocol tunnel error-disabled
state.
Enable the timer to recover from the link-flap error-disabled state.
Enable the timer to recover from a loopback error-disabled state.
Enable the timer to recover from the Port Aggregation Protocol (PAgP)-flap
error-disabled state.
Enable error detection on an SFP configuration mismatch.
See the
Enable the timer to recover from the UniDirectional Link Detection (UDLD)
error-disabled state.
Specify the time to recover from the specified error-disabled state. The range
is 30 to 86400 seconds. The same interval is applied to all causes. The default
interval is 300 seconds.
Note
Chapter 2
This error refers to an invalid small form-factor pluggable (SFP)
error-disabled state.
errdisable recovery cause small-frame
The error-disabled recovery timer is initialized at a random
differential from the configured interval value. The difference
between the actual timeout value and the configured value can be up
to 15 percent of the configured interval.
Catalyst 2350 Switch Cisco IOS Commands
command.
OL-19055-01