Show Interfaces Transceivers - Cisco WS-C2350-48TD-S Command Reference Manual

Chapter 2 Catalyst 2350 Cisco IOS Commands

show interfaces transceivers

Use the show interfaces transceivers privileged EXEC command to display the physical properties of
a small form-factor pluggable (SFP) module interface.
Syntax Description interface-id
detail
dom-supported-list
module number
properties
threshold-table
| begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2(46)EY
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show interfaces interface-id transceiver properties command:
Switch# show interfaces gigabitethernet0/1 transceiver properties
Name : Gi0/1
Administrative Speed: auto
Administrative Duplex: auto
Administrative Auto-MDIX: on
Administrative Power Inline: N/A
Operational Speed: auto
Operational Duplex: auto
Operational Auto-MDIX: on
Media Type: 10/100/1000BaseTX
OL-19055-01
show interfaces [interface-id] transceiver [ detail | dom-supported-list | module number |
properties | threshold-table ] [ | {begin | exclude | include} expression]
(Optional) Display configuration and status for a specified physical
interface.
(Optional) Display calibration properties, including high and low numbers
and any alarm information for any Digital Optical Monitoring
(DoM)-capable transceiver if one is installed in the switch.
(Optional) List all supported DoM transceivers.
(Optional) Limit display to interfaces on module on the switch. The range
is 1 to 9. This option is not available if you entered a specific interface ID.
(Optional) Display speed, and duplex settings on an interface.
(Optional) Display alarm and warning threshold table
(Optional) Display begins with the line that matches the expression
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
show interfaces transceivers
Catalyst 2350 Switch Command Reference
2-287