Spanning-Tree Transmit Hold-Count - Cisco WS-C2350-48TD-S Command Reference Manual

spanning-tree transmit hold-count

spanning-tree transmit hold-count
Use the spanning-tree transmit hold-count global configuration command to configure the number of
bridge protocol data units (BPDUs) sent every second. Use the no form of this command to return to the
default setting.
Syntax Description
value
Defaults
The default is 6.
Command Modes Global configuration
Command History Release
12.2(46)EY
Usage Guidelines Increasing the transmit hold-count value can have a significant impact on CPU utilization when the
switch is in rapid-per-VLAN spanning-tree plus (rapid-PVST+) mode. Decreasing this value might slow
down convergence. We recommend using the default setting.
Examples
This example shows how to set the transmit hold count to 8:
Switch(config)# spanning-tree transmit hold-count 8
You can verify your setting by entering the show spanning-tree mst privileged EXEC command.
Related Commands Command
show spanning-tree
Catalyst 2350 Switch Command Reference
2-432
spanning-tree transmit hold-count [value]
no spanning-tree transmit hold-count [value]
(Optional) Number of BPDUs sent every second. The range is 1 to 20.
Modification
This command was introduced.
mst
Chapter 2 Catalyst 2350 Cisco IOS Commands
Description
Displays the multiple spanning-tree (MST) region configuration
and status, including the transmit hold count.
OL-19055-01