Cisco WS-C2350-48TD-S Command Reference Manual page 276

show diagnostic
Command History Release
12.2(46)EY
Usage Guidelines
The show diagnostic post command output is the same as the show post command output.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This example shows how to display the online diagnostics that are configured on the switch:
Switch> show diagnostic content
:
Diagnostics test suite attributes:
P/V/* - Per port test / Per device test / NA
D/N/* - Disruptive test / Non-disruptive test / NA
ID
==== ================================== ============
1) TestPortAsicStackPortLoopback ---> B*N****I**
2) TestPortAsicLoopback ------------> B*D*X**IR*
3) TestPortAsicCam -----------------> B*D*X**IR*
4) TestPortAsicRingLoopback --------> B*D*X**IR*
5) TestMicRingLoopback -------------> B*D*X**IR*
6) TestPortAsicMem -----------------> B*D*X**IR*
This example shows how to display the diagnostic test results on a switch. You can also use the show
diagnostic switch command to display these diagnostic results.
Switch> show diagnostic result
:
Overall diagnostic result: PASS
Test results: (. = Pass, F = Fail, U = Untested)
This example shows how to display the running tests in a switch:
Switch> show diagnostic status
<BU> - Bootup Diagnostics, <HM> - Health Monitoring Diagnostics,
<OD> - OnDemand Diagnostics, <SCH> - Scheduled Diagnostics
Catalyst 2350 Switch Command Reference
2-252
Modification
This command was introduced.
B/* - Basic ondemand test / NA
S/* - Only applicable to standby unit / NA
X/* - Not a health monitoring test / NA
F/* - Fixed monitoring interval test / NA
E/* - Always enabled monitoring test / NA
A/I - Monitoring is active / Monitoring is inactive
R/* - Switch will reload after test list completion / NA
P/* - will partition stack / NA
Test Name
SerialNo : XXXXXXXXXXX
1) TestPortAsicStackPortLoopback ---> .
2) TestPortAsicLoopback ------------> U
3) TestPortAsicCam -----------------> U
4) TestPortAsicRingLoopback --------> U
5) TestMicRingLoopback -------------> U
6) TestPortAsicMem -----------------> U
7) TestInlinePwrCtlr ---------------> U
Chapter 2 Catalyst 2350 Cisco IOS Commands
Test Interval
Attributes day hh:mm:ss.ms shold
=============== =====
not configured
not configured
not configured
not configured
not configured
not configured
Thre-
n/a
n/a
n/a
n/a
n/a
n/a
OL-19055-01