Show Platform Tcam C - Cisco WS-C2350-48TD-S Command Reference Manual

Appendix C Catalyst 2350 Show Platform Commands
table {acl | all | l2 |
mac-address | qos |
static-address | station |
vlan-list}
[[asic number [detail [invalid]]
| [index number [detail
[invalid]] | invalid | num
number [detail [invalid]] |
invalid] | [invalid] | [num
number [detail [invalid]] |
invalid]]
| begin
| exclude
| include
expression
Note Though visible in the command-line help strings, the usage, equal-cost-route, ipv6, mcast, metprt,
multicast-expansion, pbr, unicast-direct, unicast-indirect, unicast-rpf-check, and usage keywords
are not supported.
Command Modes Privileged EXEC
Command History Release
12.2(46)EY
Usage Guidelines You should use this command only when you are working directly with your technical support
representative while troubleshooting a problem. Do not use this command unless your technical support
representative asks you to do so.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
OL-19055-01
Display lookup and forwarding table information. The keywords
have these meanings:
acl—Display the access-control list (ACL) table.
•
all—Display all the hardware memory tables.
•
l2—Display the Layer 2 lookup table.
•
mac-address—Display the MAC-address table.
•
qos—Display the QoS table.
•
• static-address—Display the static-address table.
• station—Display the station table.
vlan-list—Display the VLAN list table.
•
Display information. The keywords have these meanings:
asic number—Display information for the specified ASIC
•
device ID. The range is 0 to 15.
detail [invalid]—(Optional) Display valid or invalid details.
•
index number—(Optional) Display information for the specified
•
hardware memory table index. The range is 0 to 32768.
num number—(Optional) Display information for the specified
•
hardware memory table number. The range is 0 to 32768.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified
expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Catalyst 2350 Switch Command Reference
show platform tcam
C-27