10
Making copies
Using the MFC as a copier
You can use your MFC as a copier, making up to 99 copies at a time.
Enter Copy mode
Before making copies, make sure that
in green. If it is not, press
default setting is Fax. You can change the number of seconds or
minutes that the MFC stays in Copy mode after a copy operation.
(See Setting the Mode Timer on page 4-5.)
The printable area of your MFC begins at approximately 0.14 in.
(3.64 mm) from both sides and 0.12 in. (3 mm) from the top or bottom
of the paper.
Ex: Letter (Original)
0.14" (3.64mm)
0.12" (3mm)
(Copy)
(Copy)
to enter Copy mode. The
Letter (Paper)
Unprintable
area
MAKING COPIES 10 - 1
is illuminated