Configuring Physical Port Parameters On Fast Ethernet Ports Using The Cli - Avaya Cajun P550R User Manual

Configuring
Physical Port
Parameters on
Fast Ethernet
Ports Using the
CLI
Cajun P550/P880/P882 Switch User Guide
Table 5-5. Fast Ethernet (10/100) Port Parameters continued
Parameter Definition
Auto Select the port to auto-negotiate a speed and duplex
Negotiation mode. Auto-negotiate works best when the
Mode
connection on the other end of the link is set to auto-
negotiate as well. If you set a port to auto-negotiate,
and the connection is not successful, set the port
speed and duplex mode manually.
Auto
Determines what information the port advertises
Negotiation when it starts auto-negotiating. In most cases, 10/
Speed/Duplex 100 and Half/Full are the best settings, but there
Advertisement may be cases when you want to auto-negotiate one
parameter, while keeping the other fixed.
Rate Limit Prevents the switch from overwhelming the output
Mode buffer on lower-speed ports by placing a threshold on
the percentage of port traffic that can be flooded
packets (unknown unicasts and multicasts).
You can also optionally include known multicast
packets in this percentage to further decrease the
possibility of the port's output buffer that is being
overwhelmed.
Rate Limit Rate
Determines the percentage of a port's forwarded
traffic that can be unknown unicast and multicast
(flooded). Lower this value if the port has overflow
problems.
Rate Limit Burst Enter a value for the limit of packets allowed in a
Size single burst. Accepted values are 1 to 2048. For Fast
Ethernet ports, set this value lower than 1024
(output buffer capacity). Lower this value if the port
has overflow problems.
Port PACE
Select Enable to allow the port to detect 3Com's
Priority
proprietary PACE format as packets pass through the
port. PACE allows a packet's priority (higher priority
packets move through the switch before lower
priority packets) to be set at the adapter.
To configure ports on a Fast Ethernet module using the CLI, enter
the following command from Priv mode:
cajun# port set <options>
Refer to the Cajun P500/P880/P882 Switch Command Line Interface
Reference Guide for more details about this command.
Configuring Port Parameters
5-25