Kodak RFS 3570 User Manual page 83

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
F
ILM
F S
ILM
F
OCUS
scan — leaving a selection rectangle in the image. Then
click S to scan the cropped area into Adobe Photoshop,
CAN
resulting in a smaller image size.
NOTES: To change the size of an existing selected area, press and
hold down the Command (
move the crossbar cursor over the edge of the selection rectangle,
the crossbar turns into arrows. Drag the mouse on any corner or
side of the selection rectangle, changing the size of the selection
rectangle. Then release the Command (
To move an existing selection rectangle, place the crossbar cursor
inside the selection rectangle. Press and hold down the Command
Z
( ) key; the crossbar becomes a hand. Drag the cursor, moving the
selection rectangle to its new location. Then release the Command
Z
( ) key and mouse button.
To deselect an area, click once inside or outside the selection
rectangle.
Choose the film type you want from this popup menu.
P , N
OSITIVE EGATIVE
Select P
OSITIVE
when scanning negative film.
NOTE: Some film types include a letter code. Use these values to
match the film type from this popup menu to the edgeprint codes
printed on your negatives from KODAK Professional Films.
Choose the film size from this menu to match the film you
IZE
will scan.
NOTE: Refer to "Set the Film Size" earlier in this chapter for
additional information on this option.
Focuses the entire image. You can obtain a better overall
focus by first dragging the mouse to create a selection
rectangle around the portion of the image that is in the best
focus (and contains a significant amount of detail). Then
click F .
OCUS
©
Using the KODAK Driver for Adobe Photoshop (Macintosh)
Z
) key. With the key down, when you
Z
and many other choices are provided.
when scanning positive film and N
) key and mouse button.
EGATIVE
G
5-27