Kodak RFS 3570 User Manual page 103

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Follow these steps if none of the connected devices is
terminated internally (and any external terminator found in the
SCSI chain has been removed):
NOTE: In the following steps, you will place the Scanner at the end of the chain
of connected devices. In fact, you can place the Scanner anywhere in the chain as
long as you add a terminator to the last device in the chain.
1. Attach one end of your 50-pin to 50-pin SCSI cable to the empty SCSI
port on the last device in the chain. Seat the connector firmly, and
pinch the thin wire clamps shut.
NOTE: This cable is not packed with the Scanner but is available through
Kodak. Refer to "Appendix I — Optional Equipment & Spare Parts List." This
cable is also widely available from computer retailers; if you obtain a cable
from one of these sources, be certain to obtain a high quality cable with a
continuous EMI shield over the cable and connectors.
Back of PC
Back of One or More SCSI Devices
©
Installation (Hardware & Software) — PC
Step 1
G
7-13