Kodak RFS 3570 User Manual page 188

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Message
"The Scanner was not
found. Try the following:
Turn on Scanner Power
©
Check all cables
©
Check for SCSI ID
©
conflict
Verify TWAIN driver
©
matches installed
board
Check for blown fuse."
©
"This driver may not be
compatible with this
version of
PHOTOSHOP™"
"This driver requires 32 bit
QuickDraw to operate."
"TWAIN Error. Error
opening Data Source.
Failure due to unknown
causes." (Appears when
attempting to access the
image window with a
TWAIN acquire
command.)
D-14 Messages
© G
Possible Cause(s)
Same possible causes as
the previous message.
You have several SCSI
host adapters installed,
and the Scanner is not
connected to the host
adapter selected as the
TWAIN source.
The KODAK Driver and
your version of Adobe
Photoshop are
incompatible.
You are working with a
supported Macintosh
Computer but the 32 bit
QuickDraw file is
missing or damaged.
The KODAK Driver will
not work on an older
Macintosh Computer
that does not have 32 bit
QuickDraw.
A TWAIN compliant
KODAK Driver has not
been installed or has
been installed
improperly in the PC.
Suggested Solution(s)
Same suggested solutions as the
previous message.
Select a different TWAIN source
or turn off all equipment and
reconnect the Scanner to the
desired host adapter.
Adobe Photoshop version 2.0 or
higher is required. Upgrade if
necessary.
Install or reinstall 32 bit
QuickDraw.
You will not be able to use the
KODAK Driver on this computer;
run the driver on a different
computer.
Reinstall the driver as described
in Chapter 7 and try again.