Table of Contents
Advertisement
Function Indicator Description
By pressing
DSPL
cators can be selected.
The following flowchart describes each function indicator.
Power ON
Power ON
Frequency reference setting/monitoring
Frequency reference setting/monitoring
(Hz)
(Hz)
Sets V7TZ operating speed.
Sets V7TZ operating speed.
Output frequency monitoring (Hz)
Output frequency monitoring (Hz)
Displays frequency that V7TZ is currently
Displays frequency that V7TZ is currently
outputting.
outputting.
Setting disabled.
Setting disabled.
Output current monitoring (A)
Output current monitoring (A)
Displays current that V7 IP65 is currently
Displays current that V7 IP65 is currently
outputting.
outputting.
Setting disabled.
Setting disabled.
A Multi-function monitoring
A Multi-function monitoring
Description of the selected monitor is
Description of the selected monitor is
44
displayed.
displayed.
FWD/REV Run selection
FWD/REV Run selection
Sets the motor rotation direction when the RUN
Sets the motor rotation direction when the RUN
command is given from the Digital Operator
command is given from the Digital Operator
Setting can be changed using the
Setting can be changed using the
(forward run)
(forward run)
on the Digital Operator, each of the function indi-
or
key
or
key
(reverse run)
(reverse run)
5 Operating the Inverter
If the V7 IP65 loses power
If the V7 IP65 loses power
while in one of these
while in one of these
modes, it will return to
modes, it will return to
the same mode once
the same mode once
power is restored.
power is restored.
Monitor No.
Monitor No.
U-01: Frequency reference (FREF)
U-01: Frequency reference (FREF)
U-02: Output frequency (FOUT)
U-02: Output frequency (FOUT)
U-03: Output current (IOUT)
U-03: Output current (IOUT)
U-04: Output voltage reference (Unit: 1V)
U-04: Output voltage reference (Unit: 1V)
U-05: DC voltage (Unit: 1V)
U-05: DC voltage (Unit: 1V)
U-06: Input terminal status
U-06: Input terminal status
U-07: Output terminal status
U-07: Output terminal status
U-08: Torque monitor
U-08: Torque monitor
U-09: Fault history (last 4 faults)
U-09: Fault history (last 4 faults)
U-10: Software number
U-10: Software number
U-11: Output power
U-11: Output power
U-12: Frequency offset monitor
U-12: Frequency offset monitor
U-14: ASCII code from PLC
U-14: ASCII code from PLC
U-15: Data reception error
U-15: Data reception error
U-16: PID feedback
U-16: PID feedback
U-17: PID input
U-17: PID input
U-18: PID output
U-18: PID output
U-19: Frequency reference bias
U-19: Frequency reference bias
43
Advertisement
Table of Contents
