Table of Contents
Advertisement
Mounting/Removing Components
Removing and Mounting the Digital Operator and Covers (only build-in
inverter unit is shown, not the complete IP65 unit)
Removing the Front Cover
Use a screwdriver to loosen the screw
(section A) on the front cover. (To pre-
vent loss, this screw cannot be
removed.) Then press the right and left
sides in direction 1 and lift the front
cover in direction 2.
Mounting the Front Cover
Mount the front cover by reversing the
order of the above procedure for
removal.
Removing the Terminal Cover
• 200 V class Inverters with 1.1 kW
and more and all 400 V class
Inverters:
After removing the front cover,
press the right and left sides of the
terminal cover in direction 1 and lift
the terminal cover in direction 2.
Mounting the Terminal Cover
Mount the terminal cover by reversing
the order of the above procedure for
removal.
Removing the Digital Operator
After removing the front cover, (fol-
low the procedure on page 25) lift the
upper and lower sides (section C) of
the right side of the Digital Operator
in direction 1.
3 Mounting
1
2
1
C
A
25
Advertisement
Table of Contents
