Setup Using The Gsd File - Omron GRT1 - 27-11-2006 Operation Manual

Setup the GRT1-PRT Configuration
Reset Button
3-3-3

Setup Using the GSD File

Note
48
within the DTM. In case a mismatch is found, a warning screen will pop up to
notify the user.
Pressing the Reset button will initiate a system reset, i.e. the GRT1-PRT as
well as the attached SmartSlice I/O Units will be reset. A Reset will also force
the connected SmartSlice I/O Units to restore their settings from their non-vol-
atile storage. In some cases a reset is a necessity to force the SmartSlice I/O
Units to use newly written parameters.
Note If changes have been made via the SmartSlice I/O Unit's parameter windows,
which require a system reset, the user is notified of this through a pop notifica-
tion window.
In case third-party Master Units are used, of which the Configuration software
does not support FDT/DTM technology, the GRT1-PRT GSD File can be used
to configure that master.
1. Using the GSD File allows for I/O Configuration and I/O data exchange
with the Master unit. It does not provide easy access to other Unit param-
eters.
2. CS1/CJ1W-PRM21 PROFIBUS Master units can also be configured using
the GSD File, although the DTM is available and has many more features.
The figure below shows the Generic Slave DTM, used in Cx-Profibus to han-
dle GSD Files.
Section 3-3