Connecting The Profibus Unit And Smartslice I/O Units; Connecting Additional Smartslice I/O Units - Omron GRT1 - 27-11-2006 Operation Manual

Installing the GRT1-PRT Unit
2-2-3

Connecting the PROFIBUS Unit and SmartSlice I/O Units

Note
2-2-4

Connecting Additional SmartSlice I/O Units

Connecting Turnback
Units
18
Connect the first SmartSlice I/O Unit to the PROFIBUS Communication Unit
by aligning the sides of the Units and sliding in the SmartSlice I/O Unit from
the front. Additional SmartSlice I/O Units can be connected consecutively to
the first.
Do not touch the connector on the Unit's base block.
Connect additional SmartSlice I/O Units by aligning the sides of the Units and
sliding in the next Unit from the front. Up to 64 SmartSlice I/O Units can be
connected to one PROFIBUS Communication Unit.
Slide the Unit to the DIN Track from the front.
Insert the Unit until you hear a click, which indicates
that the Unit has locked on the Track.
It is normally not necessary to release the DIN Track
mounting hook when mounting the Unit.
When a SmartSlice I/O System is divided into blocks, connect a GRT1-TBR
Right Turnback Unit to the right end of the first block. Connect a GRT1-TBL
Left Turnback Unit to the left side of the expansion block and connect addi-
tional SmartSlice I/O Units. Use a GCN2-100 Turnback Cable to connect the
Turnback Units together.
Slide the Slice I/O Unit toward the DIN Track from
the front. Insert the Unit until you hear a click,
which indicates that the Unit has locked on the Track
It is normally not necessary to release the DIN Track
mounting hook when mounting the Unit.
Section 2-2