About This Manual - Omron GRT1 - 27-11-2006 Operation Manual

About this Manual

This manual describes the GRT1-PRT PROFIBUS Communication Unit for OMRON's SmartSlice I/O
Units. It also describes how to install and operate the Unit.
Please read this manual carefully so that you understand the information provided before installing or
using the GRT1-PRT Unit. Start with the precautions in the following section. They describe the oper-
ating environment and application safety measures which must be observed prior to and when using
the GRT1-PRT Unit.
The sections of this manual are as follows:
Section 1 introduces the GRT1-PRT Unit.
Section 2 describes the installation and setup of the GRT1-PRT Unit.
Section 3 describes the FINS commands supported by the GRT1-PRT Unit.
Section 4 describes the operational aspects of the GRT1-PRT Unit.
Section 5 provides procedures for troubleshooting the GRT1-PRT Unit.
The Appendices contain information supplementary to the information in the main body of the man-
ual. They are referred to in the various sections as required.
Manual
GRT1-series Slice I/O Units
Operation Manual
CS/CJ-series PROFIBUS DP
Master Units Operation Manual
CX-Programmer
Operation Manual
C200H-series PROFIBUS DP
Master Units
Operation Manual
CJ-series PROFIBUS DP Slave
unit
Operation Manual
GRT1-series Devicenet Commu-
nications Unit
Operation Manual
!WARNING
Failure to read and understand the information provided in this manual may result in per-
sonal injury or death, damage to the product, or product failure. Please read each section
in its entirety and be sure you understand the information provided in the section and
related sections before attempting any of the procedures or operations given.
Products
GRT1-series SmartSlice I/O
Units
SYSMAC CS/CJ-series
CS1W-PRM21
CJ1W-PRM21 PROFIBUS DP
Units
SYSMAC WS02-CXP@@-E
CX-Programmer
SYSMAC C200H-series
C200HW-PRM21
SYSMAC CJ1-series
CJ1W-PRT21
GRT1-series GRT1-DRT
Devicenet Communications Unit
Contents
Describes the Installation and Opera-
tion of the GRT1 SmartSlice I/O Units.
Describes the installation and opera-
tion of the CS1W-PRM21 and CJ1W-
PRM21 PROFIBUS Units.
Provides information on how to use
the CX-Programmer, programming
software which supports CS1/CJ1-
series PLCs.
Describes the Installation and Opera-
tion of the C200HW-PRM21 PROFI-
BUS DP Master Units.
Describes the Installation and Opera-
tion of the CJ1W-PRT21 PROFIBUS
DP Slave Units.
Describes the Installation and Opera-
tion of the GRT1-DRT Devicenet Com-
munications Unit.
Cat. No.
W455-E1-@
W409-E2-@
W446-E1-@
W349-E2-@
W408-E2-@
W454-E1-@
vii