Omron E5AN User Manual page 341

Setting Levels Diagram
This diagram shows all of the setting levels. To move to the advanced function setting level and calibration
level, you must enter passwords. Some parameters are not displayed depending on the protect level setting
and the conditions of use.
Control stops when you move from the operation level to the initial setting level.
Start in manual mode.
Start in automatic mode.
Press the O Key or the
PF Key for at least 1 s.
(See note 4.)
a-m
Press the O Key
(See
for at least 3 s while
Manual
a-m is displayed.
note
mode
(a-m will flash after
3.)
1st second.)
Press the PF Key
for at least 1 s.
Manual
Control Level
Note (1) You can return to the operation level by executing a software reset.
(2) It is not possible to move to other levels from the calibration level by operating the keys on the front
panel. It can be done only by first turning OFF the power.
(3) From the manual control level, key operations can be used to move to the operation level only.
(4) When the PF Setting parameter is set to A-M for a Controller with a PF Key (E5AN/EN).
(5) When the PF Setting parameter is set to PFDP for a Controller with a PF Key (E5AN/EN)
Power ON
Operation
Level
Press the
O Key less than 1 s.
PF Key
(See note 5.)
(See note 4.)
(See
note 1.)
Press the
O Key for
at least 1 s.
Initial Setting
Level
Press the O Key
for at least 1 s.
Advanced Function
Setting Level
Calibration Level
Adjustment
Level
PF Key
(See note 5.)
Monitor/Setting
Item Level
Press the O Key for at
least 3 s. (Display will flash
after 1st second.)
25
c
100
Control stops.
Communica-
tions Setting
Level
Press the
O Key for less than 1 s.
Input password while
amoV is displayed. (Set
value 169)
Input password.
(See
note 2.)
Appendix
Press the
O+ M
Press the Keys for at
O+ M least 1 s.
Keys for at
least 3 s.
c 25
(Display
will flash
100
after 1st
second.)
Protect Level
Note The time taken to move
to the protect level can
be adjusted by chang-
ing the "Move to pro-
tect level time" setting.
(Refer to page 228.)
Control in progress
Control stopped
Not displayed for some models
Level change
305