Omron E5AN User Manual page 251

Initial Setting Level
Note
Note
See
See
The following tables show the relationships between ON/OFF combinations of
event inputs 1 and 2 and selected set points.
Number of Multi-SP Uses: 1:
Even input 1
OFF
ON
Number of Multi-SP Uses: 2
Even input 1
OFF
ON
OFF
ON
• The following table shows the functions assigned when an Event Input
Assignment (1 or 2) is displayed.
Setting
none
stop
manu
prst
drs
at-2
at-1
wtpt
lat
(1) PRST (Program Start) can be set even when the Program Pattern param-
eter is set to OFF, but the function will be disabled.
(2) This function can be set for heating/cooling control, but the function will
be disabled.
• When any of the following functions is set for an Event Input Assignment
parameter, the same function cannot be set for another Event Input
Assignment parameter: STOP (RUN/STOP), MANU (Auto/Manual
Switch), PRST (Program Start), DRS (Invert Direct/Reverse Operation),
AT-2 (100% AT Execute/Cancel), AT-1 (40% AT Execute/Cancel), WTPT
(Setting Change Enable/Disable), or LAT (Alarm Latch Cancel).
Event inputs can be used on the E5CN-@M@ (with an E53-CN@B@N2) or
E5AN/EN-@M@-N (with an E53-AKB) Controllers. Turn event inputs ON and
OFF while the power is being supplied. Event input ON/OFF changes are
detected for inputs of 50 ms or longer.
■ Related Parameter
SP0 to SP3 (adjustment level): Page 186
Event input assignment 1 and 2: Page 216 (initial setting level), Multi-SP use:
Page 220 (advanced function setting level)
Selected set point
Set point 0
Set point 1
Even input 2
OFF
OFF
ON
ON
Function
None
RUN/STOP
Auto/Manual Switch
Program start (See note 1.)
Invert Direct/Reverse Operation
100% AT Execute/Cancel
40% AT Execute/Cancel (See note 2.)
Setting Change Enable/Disable
Alarm Latch Cancel
Section 5-7
Selected set point
Set point 0
Set point 1
Set point 2
Set point 3
215