Omron E5AN User Manual page 208

Operation Level
r-s
RUN/STOP
Operation
See
See
al-1
Alarm Value 1
Function
Setting
See
See
172
This parameter starts and stops the control operation.
When run (RUN) is selected, control is started. When stop (STOP) is
selected, control is stopped. The STOP indicator will light when control.
The default is run.
This parameter will not be displayed if an event input is set to "RUN/STOP."
This parameter is set to one of the input values "X" in the alarm type list.
• This parameter sets the alarm value for alarm 1.
• During temperature input, the decimal point position depends on the cur-
rently selected sensor, and during analog input it depends on the Decimal
Point parameter setting.
Setting range
1999 to 9999 EU
■ Related Parameters
Input type: Page 200, Scaling upper limit, Scaling lower limit, Decimal point
(initial setting level): Page 202 (initial setting level)
Alarm 1 type (initial setting level): Page 207
Standby sequence reset: Page 221, Auxiliary output * open in alarm: Page
222, Alarm 1 hysteresis: Page 209, Alarm 1 latch: Page 227 (advanced func-
tion setting level)
The Event Input Assignment 1 and 2
parameters must not be set to "RUN/
STOP."
Alarm 1 must be assigned.
The alarm 1 type must not be 0, 1, 4,
5, or 12.
Unit Default
0
Section 5-3