Upgrading Firmware; Configuration Screen; Figure 80 Firmware Upload: Warning; Figure 81 Firmware Upload: Progress Status - ZyXEL Communications NBG-510S User Manual
802.11g wireless remote access broadband gateway
Hide thumbs
Also See for NBG-510S:
- Quick start manual (103 pages) ,
- Support note (42 pages) ,
- Release note (5 pages)
Table of Contents
Advertisement
Chapter 19 Tools
Do not turn off the ZyXEL Device while firmware upload is in progress!
19.1.1 Upgrading Firmware
The following steps describes the firmware upgrade process.
1 Specify the firmware file in the Firmware Upgrade screen and click Upload to start the
file transfer process.
2 A warning screen displays as shown. Click OK to continue.
Figure 80 Firmware Upload: Warning
3 A status bar displays to indicate that the file transfer process is in progress.
Figure 81 Firmware Upload: Progress Status
4 After the file transfer is complete, the ZyXEL Device automatically reboots, in this time
causing a temporary network disconnect. A warning screen displays as shown. Do NOT
restart the ZyXEL Device at this point.
Figure 82 Firmware Upload: Reboot
5 After the ZyXEL Device finishes rebooting, the login screen displays. Otherwise, access
the login screen again. Log in and check your new firmware version in the Status screen.
19.2 Configuration Screen
Click Maintenance > Tools > Configuration. Information related to factory defaults, backup
configuration, and restoring configuration appears as shown next.
126
NBG-510S User's Guide
Advertisement
Table of Contents
Troubleshooting
