Static Route; Chapter 16 Static Route; Ip Static Route; Ip Static Route Screen - ZyXEL Communications NBG-510S User Manual

C
H A P T E R
This chapter shows you how to configure static routes for your ZyXEL Device.

16.1 IP Static Route

Each remote node specifies only the network to which the gateway is directly connected, and
the ZyXEL Device has no knowledge of the networks beyond. For instance, the ZyXEL
Device knows about network N2 in the following figure through remote node Router 1.
However, the ZyXEL Device is unable to route a packet to network N3 because it doesn't
know that there is a route through the same remote node Router 1 (via gateway Router 2). The
static routes are for you to tell the ZyXEL Device about the networks beyond the remote
nodes.

Figure 73 Example of Static Routing Topology

16.2 IP Static Route Screen

Click Management > Static Route to open the IP Static Route screen.
NBG-510S User's Guide
16

Static Route

113