Command Modes; Using Command History; Figure 132 Cli Help: Detailed Command Information: Example 1; Figure 133 Cli: Help: Detailed Command Information: Example 2 - ZyXEL Communications ZyXEL Dimension ES-4024 User Manual

Figure 132 CLI Help: Detailed Command Information: Example 1

ras> ping help
Usage: ping <hostid>
ras>

Figure 133 CLI: Help: Detailed Command Information: Example 2

ras> ping ?
<ip|host-name>
ras>

37.6 Command Modes

There are three CLI command modes: User, Enable and Configure.
When you first log into the CLI, the initial command mode is the User mode. The User mode
commands are a subset of the Enable mode commands. The User mode command prompt ends
with an angle bracket (>).
To enter Enable (or privileged) mode, type
default is 1234). When you enter the Enable mode, the command prompt changes to the pound
sign ( ).
#
To enter the configuration mode, type
prompt consists of the word
configuration modes: interface, router and VLAN.
• To enter config-vlan mode, type
example,
• To enter config-interface mode and configure the ports, enter
channel
• To configure the routing domain, enter
domain IP address and subnet mask bits (for example,
192.168.1.1/24
• Use the
Enter
exit

37.7 Using Command History

The switch keeps a list of up to 256 commands you have entered for the current CLI session.
You can use any commands in the history again by pressing the up ( ) or down ( ) arrow key
to scroll through the previously used commands and press
to display the list of commands.
Chapter 37 Introducing the Commands
config
to configure settings for VLAN 10.
vlan 10
followed by a port number. For example,
).
commands to configure the routing protocol settings.
router
or to quit from the current mode or log out from the CLI.
logout
destination ip address
and enter a password when prompted (the
enable
or
configure config
and the pound sign ( ). There are various sub
#
followed by a number (between 1 to 4094). For
vlan
interface port-channel 10
interface route-domain
interface route-domain
[ENTER]
ES-4024A User's Guide
. The Configure mode command
interface port-
followed by the
. Use the history command
.
207