Test Procedures; Case Cover Removal And Replacement Procedure - Lincoln Electric Fleet 650 Service Manual

LINCOLN ELECTRIC

Test Procedures

CASE COVER REMOVAL AND REPLACEMENT PROCEDURE

Service and repair should be performed by only Lincoln Electric factory trained personnel. Unauthorized
repairs performed on this equipment may result in danger to the technician or machine operator and will
invalidate your factory warranty. For your safety and to avoid electrical shock, please observe all safety
notes and precautions detailed throughout this manual. If for any reason you do not understand the test
procedures or are unable to perform the test/repairs safely, contact the Lincoln Electric Service Department
for electrical troubleshooting assistance before you proceed. Call 1-888-935-3877.
TEST DESCRIPTION
This procedure will aid the technician in the removal and replacement of the Case Covers.
MATERIALS NEEDED
1/2" Nutdriver
Wiring Diagram
REMOVAL PROCEDURE
1. Turn off the engine of the Fleet 650 machine.
2. Slide the door assembly off of the door slide. See Figure F.1.
3. Using a 1/2" nutdriver, remove the nine screws and flat washers securing the door slide to the
machine. See Figure F.1. Remove the door slide.
4. Using a 1/2" nutdriver, loosen (do not remove) the two bottom screws securing the right case side
to the machine. See Figure F.1.
5. Using a 1/2" nutdriver, remove the six screws and flat washers securing the right case side to the
machine. See Figure F.1. Remove the right case side.
6. Using a 1/2" nutdriver, remove the nine screws and flat washers securing the roof to the machine.
See Figure F.1.
7. Remove the cover seal, fuel cap and fuel trough.
8. Remove the roof.
9. Attach the fuel cap.
10. Using a 1/2" nutdriver, remove the six screws and flat washers securing the front case side to the
machine. See Figure F.2.
11. Using a 1/2" nutdriver, loosen (do not remove) the two bottom screws securing the front case side
to the machine. See Figure F.2. Remove the front case side.
12. Using a 1/2" nutdriver, remove the two screws and flat washers securing the engine case side to the
machine. See Figure F.2.
13. Using a 1/2" nutdriver, loosen (do not remove) the two bottom screws securing the engine case side
to the machine. See Figure F.2. Remove the engine case side.
Fleet™ 650 Service Manual
16