Connecting To The Network; H Connecting To A Dte - Paradyne 7974 User Manual

Connecting to the Network

"
Connecting to a DTE
7900-A2-GB21-00
Procedure
To connect your unit to the network:
1. Connect one end of the network cable into the rear panel DSL jack.
2. Connect the other end to your DSL network interface.
NOTE:
Do not use a flat VF network cable as this may severely degrade the
performance of the unit. Use only Cat 5 twisted-pair network cable.
As the following table shows, the DTE interface varies from model to model.
Model DTE Connection
7974 The DSX-1 interface is an RJ48C, 8-position, unkeyed modular connector. An
RJ48C-to-DB15 T1 network interface adapter cable is available from Paradyne.
7975 The synchronous interface is a 25-pin EIA-530-A interface. Depending on the
cable used, the interface can be adapted to an X.21, RS-449, or V.35 interface.
7976 The G.703 interface is either two BNC connectors (Transmit and Receive) for a
75-ohm unbalanced interface or an RJ48C, 8-position, unkeyed modular
connector for a 120-ohm balanced interface.
See Appendix C, Cables and Pin
August 2000
Initial Startup and Configuration
Assignments, for more information.
3-3