H System Options Menu - Paradyne 7974 User Manual

System Options Menu
For System Options, refer to Table A-7. To access the System Options screen,
follow this menu selection sequence:
Î Î
7900-A2-GB21-00
Main Menu Configuration
main/config/system
DSL Mode:
Test Timeout:
Test Duration (min):
Telco Initiated Loopback:
Remote Telco Line Loopback:
G.703 Line Termination:
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu
Save
Table A-7. System Options (1 of 2)
DSL Mode
Possible Settings: LTU, NTU
Default Setting: NTU
Controls whether the unit is configured as a control unit or tributary unit.
LTU – The unit is configured as a control unit (Line Termination Unit).
NTU – The unit is configured as a tributary unit (Network Termination Unit). This unit
requests its IP address from the LTU during establishment of the PPP link.
NOTE: Changing this option resets the termination unit.
Test Timeout
Possible Settings: Enable, Disable
Default Setting: Enable
Allows tests to end automatically. The feature should be enabled when the unit is
remotely managed so that control can be regained after a test is accidentally executed.
Enable – Loopback and pattern tests end when test duration is reached.
Disable – Tests run until manually terminated from the Network Tests screen or
remotely (network initiated tests). Refer to
Test Duration (min)
Possible Settings: 1–120
Default Setting: 10
Number of minutes for a test to be active before automatically ending.
H
Test Duration (min) appears when Test Timeout is enabled.
1 to 120 – Amount of time in minutes a test runs before terminating.
August 2000
Load Configuration From
SYSTEM OPTIONS
NTU
Enable
10
Enable
Disable
120 Ohm
Running Network Tests
Configuration Options
System
Model: 797x
(Model 7974)
(Model 7974)
(Model 7976)
Î Î Î Î
MainMenu Exit
in Chapter 8, Testing.
A-13