H Synchronous Data Port Options For Model 7975 - Paradyne 7974 User Manual

Configuration Options
Synchronous Data Port Options for Model 7975
Î
A-8
For Synchronous Data Port Options, refer to Table A-5. To access the
Synchronous Data Port Options screen, follow this menu selection sequence:
Main Menu Configuration
main/config/sync_data
SYNCHRONOUS DATA PORT OPTIONS
Port Type:
Payload Rate:
Transmit Clock Source:
Send All Ones on Data Port Not Ready:
Action on Network LOS Alarm:
Network Initiated Data Channel Loopback:
Port (DTE) Initiated Loopbacks:
Elastic Store:
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl–a to access these functions, ESC for previous menu MainMenu Exit
Table A-5. Synchronous Data Port Options for Model 7975 (1 of 3)
Port Type
Possible Settings: E530A, V.35, RS449, X.21
Default Setting: E530A
Determines the port type for the data port.
E530A – The port is configured as an EIA-530-A compatible DCE. An EIA-530-A
compatible DTE can be connected directly to the DB25 Port connector on the rear panel
of the unit.
V.35 – The port is configured as a V.35 compatible DCE. A V.35 compatible DTE can be
connected using an MS34 to DB25 adapter cable to connect to the DB25 Port
connector on the rear panel of the unit.
E530A – The port is configured as an RS449 compatible DCE. An RS449 compatible
DTE can be connected using a DB37 to DB25 adapter cable to connect to the DB25
Port connector on the rear panel of the unit.
X.21 – The port is configured as an X.21 compatible DCE. An X.21 compatible DTE can
be connected using a DB15 to DB25 adapter cable to connect to the DB25 Port
connector on the rear panel of the unit.
August 2000
Load Configuration From
E530A
2320 Kbps
Internal
Both
Halt
Disable
Disable
Enable
SYNC Ports
Model: 7975
Î Î
7900-A2-GB21-00